Filter
Top Products
Follow the appropriate procedure below to renumber the
system. Be sure to update all of the planning forms that
are affected by the replacement or addition of a module.
With a Display Console
1
2
3
4
Enter administration mode by sliding the T/P switch to
P.
Press Conference twice.
The administration menu appears.
From the administration menu, press
[System], [More],
[Renumber]
.
YOU see the message, “System is restarting. ..” When the
renumbering is complete, the administration menu appears on the
display.
Press
Conference
to return to the administration menu
or leave administration mode by sliding the T/P switch
to the center position.
With a BIS-34D Console
1
Enter administration mode by sliding the T/P switch to
P.
2
3
4
5
Press
Conference
twice.
Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.
Press
Message.
Dial #299.
Lights next tO Adm Tel, Adm Pool Message, and Speaker begin
to flash. You hear two beeps and then see the message, ‘System is
Re-starting..."
If only the light next to Message flashes, one or
more calls are in progress and the procedure is not executed until
the light becomes steady.
Continue administration or leave administration mode
by sliding the T/P switch to the center position.
3-64 Administering a Changed System