Filter
Top Products
CONNECTING VOICE
TERMINALS TO THE
SYSTEM
TESTING THE VOICE
TERMINALS
To connect each voice terminal to the system, do the
following:
1 Place the voice terminal in its designated location.
2 Plug the voice terminal into the system either by direct
connection or through a jack field.
Connecting a voice terminal to the control unit directly
requires one or more modular cords. Connect one end of
the cord to the jack on the voice terminal. Connect the
other end of the modular cord to a station port on a system
module in the control unit. Refer to “Connecting Voice
Terminal Wiring Directly” on page 2-25.
Connecting a voice terminal to the control unit through a
jack field requires that cables from the voice terminals and
control unit be connected to a jack field. Refer to “Jack
Field Wiring” on page 2-33 for more information.
.
Perform the following steps to verify that the voice
terminals are connected properly.
1
2
3
4
Make sure that the Test/Program switch on the left side
of each voice terminal is set to the center position.
This step prevents the phones from ringing when the
power at the control unit is turned on.
If the power to the control unit is not turned on, turn on
the power at the control unit using the procedure
described in “Applying Power to the System” on page
2-90.
Slide the T/P switch to
T.
On some voice terminals
you will have to hold it there to keep it from springing
back to the center position.
All the red and green lights on the voice terminal begin flash,
and a tone sound.
Slide the T/P switch to the center position.
The lights stop flashing and the tone stops.
Connecting the Voice Terminals 2-95