Filter
Top Products
SETTING SYSTEM
TYPE
5 Dial number
to
designate system size:
0 = small
1 = large
The message “System is Re-starting... ” appears. When
renumbering is complete, after a short delay, the lights flash next
to Adm Tel, Adm Pool, Message, and Speaker.
6 Continue administration or leave administration mode
by sliding the T/P switch to the center position.
Refer to the System Configuration Form for Feature
Module 2 or Form 1e, System Form- Requirements and
Options to determine the system type: square, behind-
switch, or pooled. If the system is to be pooled, determine
the method to be used to access line pools: Button
Access,
Dial
Access, or Automatic Route
(ARS).
.
With a Display Console
Selection
1
2
3
4
Enter administration mode by sliding the T/P switch to
P.
Press
Conference
twice.
The administration menu
appears.
Press
[System], [Type].
The type screen appears.
Press the appropriate button:
>For a square system, press:
[Square],
>For a pooled system, press one of the following:
[ButnAcc], [ARS], [DialAcc].
>For a behind switch system, press [More],
[BehindSw].
The message “System is Re-starting...” appears, followed by the
administration menu after a short delay.
3-22 Administering a New System