Filter
Top Products
SELECTING THE
DISCONNECT TIME
To select the disconnect time for tie lines, follow these
steps:
1
2
3
4
5
6
7
8
9
10
Enter administration mode by slding the T/P switich to
P.
Press
Conference
twice.
The administration menu appears.
Press
[More], [More], [More], [TieLines], [More], [More].
[InDisc] .
The in disconnect screen appears.
Dial the line number or press the line button of a tie
line, then press
[Enter].
The current setting is displayed.
Press
[Drop]
to remove the old setting.
NOTE:
Press
[Exit]
if you do not want to change the
setting.
The in disconect screen appears.
Dial the new setting.
> time = 140 to 2400 ms (increments of 10)
> time = 300 (default)
NOTE:
Use the backspace button to erase numbers
incorrectly dialed.
Press
[Enter].
The system will round down to the
nearest increment.
The in disconnect screen appears.
Repeat steps 4 and 7 for each line port.
Press
[Exit]
and repeat steps 3 through 8 again, except
select [OutDisc] instead of [InDisc] to select the outgoing
disconnect time.
Press Conference to return to the main administration
menu, or leave administration mode by sliding the T/P
switch to the center position.
3-58 Administering a New System