Filter
Top Products
I
4
5
6
7
8
9
10
11
Touch a programmable button.
Dial
✱
09 plus the slot number of the module to be
removed (01 through 11) to select that slot
The green light next to Intercom Ring will flash. The red light
next to Intercom Voice indicates activity on the module.
Flashing red light =activity
Steady red light =no activity
NOTE:
Digital station modules with only data calls
active do not show the flashing red light for
activity. Extra care is needed to avoid
dropping active data calls.
If the red light is flashing, or if the module
has MPDMs or MTDMs connected to it that
have the “Call In Progress” light on, skip this
module by dialing
✱
09 plus a new slot
number. If you reset the module when it is
active, any active voice or data calls will be
dropped.
If you decide to change a digital module
despite the presence of active calls, remove
the station cords before resetting the module.
To idle a module, touch Intercom Voice. The
appropriate module will be idled.
The red light will be on steady next to Intercom Voice.
The green light next to Intercom Ring will go on steady.
Remove all line and/or station cords connected to the
module that is to be removed.
Replace the designated module with a module of the
same type.
Reconnect all line and/or station cords that were
connected to the module.
Touch Intercom Ring to restore the module.
The red light on the Processor Module will go on for a short time.
Repeat steps 4 through 10 for any other module to be
replaced.
On-Line Module Swap 4-9