Filter
Top Products
MOVING A VOICE
TERMINAL
2
3
4
If the voice terminal locations connect to the control
unit
through a jack field, install a wiring run for each
new voice terminal location according to the
instructions in “Jack Field Wiring,” on page 2-33. If
the voice terminals connect directly to the control unit,
see "Connecting Voice Terminal Wiring Directly" on
page 2-25.
To connect the new voice terminal to the system, see
the
instructions in
“Connecting the Voice Terminals,”
on page 2-92.
Record the new
information in the system directory
and on the appropriate planning form. For Release 3,
record this information on Form 1d, Systern Form–
Station Planning and the appropriate Station
Configuration form (Form 3b, Form 3c, Form 3f, or
Form 3g). For Feature Modules 1 and 2, record this
information on the Master Planning Foirm, Station Jack
section and the appropriate Station Configuration
Form.
You can easily move
a voice terminal from one location to
another within your system without having to reprogram
the voice terminal.
To move
a voice terminal, do the following:
1 Make sure the necessary wiring is in place at the new
location (see "Voice Terminal Wiring" on page 2-23).
Check Form 1d, System Form–Station Planning for
Release 3 or the Master Planning Form for Feature
Modules 1 and 2 for the number assignments.
2 Unplug the voice terminal at its old location, and plug
it in at its new location.
Modifying the System 2-115