Filter
Top Products
With a BIS-34D Console
DESIGNATING
ATTENDANT
POSITIONS
1
2
3
4
5
6
Enter administration mode by sliding the T/P switch
to
P.
Press
Conference
twice.
Lights flash nexto to Adm Tel, Adm Pool, Message, and Speaker.
Press
Message.
The green light goes on steady next to Message. All flashing lights
go off.
Dial #202.
Two beeps sound.
Dial the appropriate number:
0 = Square
1 = Pooled with Button Access to line pools
2 = Pooled with Dial Access to line pools
3 = Pooled with Automatic Route Selection
4 = Behind switch
The message “System is Re-starting..." appears. When
renumbering is complete, afier a short delay, the Lights jlash next
to Adm Tel, Adm Pool, Message, and Speaker.
Continue administration or leave administration mode
by sliding the T/P switch to the center position.
Refer to the Master Planning Form for Feature Module 2
or Form 3a, System Form-Station Planning to determine
which voice terminals should be attendant positions.
NOTE:
The system is factory set with the station
connected to jack 01 (default intercom number
10) as an attendant position, and this
cannot
be
changed.
Keep in mind that there cannot be more than eight
attendant positions; therefore, you can designate up to
seven additional attendant positions. There
can be only
two attendant ports on each analog station module. Every
fourth analog station port after port 01 (default intercom
number 10) can be designated an attendant position. If
Administering a New System 3-23