Filter
Top Products
MODULE DOESN'T
WORK
Symptom: A module doesn't work properly in a slot.
Possible Cause
Possible Solution
To Investigate Further
1. The module needs to be
To correct this problem, it is
If the module is correctly
cleared of previous
preferable
LO
have a printer
administered for the system
administration.
to check previous
and it still doesn’t work go
to
administration.
Possible Cause 2.
If you have a printer:
Enter administration mode
and dial #905. The printout
shows what type of module
the operating system is
expecting. If the module is
not administered correctly
for the system, follow
instructions under
“Renumbering After
Replacing or Adding
Modules” on page 3-63 to
renumber the system.
If you don’t have a printer
If the module is correctly
to check previous
administered for the system
administration:
and it still doesn’t work go to
F
O
llow instructions under
Possible Cause 2
“Renumbering After
Replacing or Adding
Modules”’ on page 3-63 to
renumber the system. Note
that by doing so you will lose
all previous administration.
If the module works, you
have corrected the problem.
Check your administration
forms and readminister the
system.
Procedures for Specific Symptoms 4-49