Filter
Top Products
If a user needs to access specific lines or line pools,
refer to the list of dial codes on the Station
Configuration Form, Basic Telephones (Pooled
Systems) for Feature Module 2 or Form 3e, Station
Configuration Form, Basic Telephones (Pooled
Systems) for Release 3.
•
In a behind-switch system, users are connected to their
prime lines automatically when they lift the handset.
The prime line is the user’s line in the host system.
•
Users with basic telephones cannot enter a password to
make calls while Night Service with Outward
Restriction is in effect unless they are assigned to the
Night Service Exclusion list.
BASIC TELEPHONES
The procedure for administering basic telephones
CONNECTED TO
connected to interface devices is slightly different from
TELEPHONE
the procedure for administering voice terminals. Follow
INTERFACE DEVICES
the steps below to administer a basic telephone connected
to an Off-Premises Telephone Interface (OPTI), a Basic
Telephone and Modem Interface
(BTMI), or a Basic
Telephone and Modem Interface
2 (BTMI-2).
1
At the administrator/attendant console, enter
administration mode by sliding the T/P switch to
P.
2
Press
Conference
twice.
3
Assign lines and line pools to the intercom number
assigned to the OPTI, BTMI, or BTMI-2. Do this by
following the “Assigning Lines/Line Pools to Stations
for Square, Button Access, and Behind-Switch
Systems” procedure on page 3-36.
4
To assign call restrictions to an OPTI, BTMI, or
BTMI-2, follow the “Call Restrictions” procedure on
page 3-79 for a Display Console or page 3-98 for a
BIS-34D Console.
3-112 Administering Basic Telephones