Filter
Top Products
4
5
6
7
8
9
10
Press
[Single]
.
Press the appropriate button for the type of dial code
you want to change. The choices are the following:
[Station] [Pools] [Page Zns] [GrpCall]
Take
one
of the actions below to indicate the “old” dial
code.
NOTE:
> Dial
The third action can only be used for lines or
stations.
the current number of the line, station, line
pool, or group.
> Dial the logical ID number. Be sure to enter the
pound sign (#) before the number.
NOTE:
Logical ID numbers run from lowest to
-highest, with the lowest number being #1.
For example, to specify line pool 9, you
would enter "#l ."
Pool 890 is #2, Pool
891 is #3, etc. Note that logical ID
numbers for lines and stations are
preprinted on the administration overlay.
> If you’re identifying a line or station, press its line
button or Auto Intercom button.
The
light
next to the button goes on.
Press
[Enter].
.
The display shows the old number and prompts you to enter the
new number-
Dial the new Flexible Number code.
Press
[Enter].
.
The system reiurns you to the Single Renumber screen.
Press Conference to return to the administration menu
or leave administration mode by sliding the T/P switch
to the center position.
Administering a New System
3-31