Filter
Top Products
3
4
5
6
Press
Message.
Dial #999 and wait for the beep.
Press
Message.
Wait until printing is complete before leaving
administration mode. Don’t remove the printout until
after you’ve Ieft administration mode or printing page
alignments will be affected.
Leave administration
mode by sliding the T/P switch
to the center position.
lNITIALIZING
When the MERLIN II system is first setup, it assigns
STATION POSITIONS
default dialing codes to stations, lines, line pools, and Call
(CHANGING
Distribution and Group Page
Groups.
See “Default
INTERCOM
Settings” on page 3-15.
-
NUMBERS TO MAKE
.
SPACE IN THE DIAL
NOTE
PLAN)
Because
dialing plan leaves few numbers available for use as
Flexible Numbering codes. To make space available in
the dial plan you need to perform the Initialize Station
Position procedure.
It also assigns codes to agent splits for the Call
Management System (CMS) that is available
with Feature Module 2 only. For additional
information, see the
MERUN II Communications
System System Manual for the Call Management
System.
dialing plan numbers must be unique, the default
This procedure renumbers the stations in the system so
that they are all in the 7000 range by placing 70 or 7
before their default intercom numbers, i.e., 7010 through
7069 and 7700 through 7759. This saves you time and
makes Flexible Numbering codes 1000 through 6999
available for use. To assign intercom numbers in the 7000
range to all stations and change default codes to lines, line
pools, tie lines, Call Distribution Groups, and Group Page
Groups:
3-28 Administering a New System