Filter
Top Products
ASSEMBLING THE
VOICE TERMINALS
The following voice terminal items come boxed together:
Voice terminal body
Handset
●
Coiled handset cord
●
Modular voice terminal cord
●
Desk stand and/or wall mount
●
Instructions for assembling the voice terminal
●
Refer to Figure 2-25 and follow the steps below to
assemble each voice terminal:
1
2
3
4
5
6
Attach the desk stand or wall mount to the voice
terminal.
Plug one end of the coiled handset cord into the
handset.
Plug the other end of the coiled handset cord into the
jack near the handset rest at the lower edge of the
voice terminal body. The jack may also be located at
the base of the voice terminal body next to the handset
symbol.
Make sure that the Test/Program (T/P) switch, also On
the left side of the voice terminal, is set to the center
position. If the switch is set to
T
or
P,
the voice
terminal will begin ringing as soon as you connect it to
a system that is turned on.
Slide the volume control on the left side of the voice
terminal to the center position to adjust the ringer
volume.
Thread the modular voice terminal cord between the
desk stand and back of the voice terminal, then plug
the cord into the jack labeled “LINE” on the voice
terminal.
Connecting the Voice Terminals 2-93