Filter
Top Products
Setting Options
IDENTIFYING MUSIC-
ON-HOLD LINE JACK
If the MERLIN
II
system has Music-on-Hold, you need to
identify the control unit line jack to which the music
source is connected. Remember that the Music-on-Hold
line can't be placed in a line pool, assigned to a voice
terminal, used for Loudspeaker Page, or used as a Direct
Inward System Access (DISA) line.
NOTE:
If you have a pooled system, you must remove
the line designated for Music-on-Hold from the
main pool, where it is assigned by default before
you can identify it as the Music-on-Hold line. If
you haven't already done so, follow the
instructions under “Assigning Lines to Line
Pools” on page 3-32, then continue with this
procedure.
Follow the appropriate procedure below to identify the
Music-on-Hold line jack.
.
With a Display Console
1
2
3
4
5
Enter administration mode by sliding the TIP switch to
P.
Press
Conference
twice.
The administration menu appears.
Press
[More], [Options], [Music].
The system prompts you to indicate the Music-on-Hold
line jack by pressing the appropriate line button. Each
successive press of a button gives you one of the
following codes:
Green light on = jack is assigned for Music-on-Hold
Green light off = jack is for a standard line or loudspeaker page
Press
Conference
to return to the administration menu
or leave administration mode by sliding the T/P switch
to the center position.
Administering a New System 3-45