Filter
Top Products
1 Enter Administration mode by sliding the T/P switch to
P
.
2 Press Conference twice.
The administration menu appears.
3 Press [More], [More], [More], [TieLines], [More], [More].
[More], [InDPin]
.
The inward dial plan screen appears.
4 Press [Block] .
5 Press
[Stations] .
6 Dial the first (lowest numbered) new dial code.
7 Press
[Enter]
.
The system renumbers all the stations sequentially, then returns
you to the block renumber screen.
8 Press
Conference
to return to the main administration
menu, or leave administration mode by sliding the T/P
switch to the center.
PRINTING THE
INWARD DIAL PLAN
To get a printout of the inward dial plan, follow these
steps:
1
2
3
4
Enter administration mode by sliding the T/P switch to
P.
Press
[More], [More], [Print], [More], [More], [More],
[More], [InDPin]
.
Press
Conference
twice.
The administration menu appears.
Wait until printing is complete before leaving
administration mode. Don’t remove the printout until
after you’ve left administration mode or printing page
alignments will be affected.
Press Conference to return to the main administration
menu, or leave administration mode by sliding the T/P
switch to the center position.
Administering a New System
3-61