Filter
Top Products
Programming
2-16
— VMS Hunt Schedule (#507) determines when outside calls should
ring the VMS Hunt Group (always, day only, or night only) depending
on the status of the Night Service Button (#503) at extension 10.
— Automatic VMS Cover (#310) determines whether or not an
extension’s unanswered intercom and transferred calls and outside
calls on lines assigned ownership are automatically covered by the
voice messaging system.
— VMS Cover Rings (#117) specifies the number of times intercom
and transferred calls or outside calls on lines assigned ownership
ring at extensions before they are sent to the voice messaging
system.
— Transfer Return Extension (#306) identifies the extension to which
a call transferred by the voice messaging system should be routed if
the destination extension does not answer and does not have voice
mail coverage active. (The transfer return extension for the voice
messaging system is typically extension 10.)
NOTE:
If an extension has VMS Cover and Call Coverage active, intercom and
transferred calls and outside calls on lines assigned ownership ring at the
covering extension after the specified number of Call Coverage Rings
(#116). Then:
■ If the covering extension does not answer, the call is routed after the
specified number of VMS Cover Rings (#117) to the voice mailbox of the
extension that activated Call Coverage.
■ If the covering extension has Do Not Disturb active, the call is immediately
routed to the voice mailbox of the extension that activated Call Coverage.
Backup and Restore Features
The PARTNER Endeavor 362 processor module has one PC Card slot. This slot
functions similarly to a floppy drive on a PC, in that information can be added to
the system or copied from the system using a PC Card inserted into the slot. To
use the optional Backup and Restore features of the system, you must purchase a
Backup/Restore PC Card from Lucent Technologies. Only these Lucent
Technologies PC Cards can be used in the PARTNER Endeavor processor
module. The same PC Card stores both automatic and manual backups
separately. To install a Backup/Restore PC Card, see
PARTNER PC Card
Installation Instructions
.
Backup Programming—Automatic (#123) enables you to specify whether
automatic backups should be performed or not. If you set this feature to “Active,”
your system and telephone programming settings are backed up to the PC Card
automatically at 2:00 a.m. on the first day of each month. The PC Card must be
present in the PC Card slot for the backup to take place.