Filter
Top Products
System Components
1-5
Configurations
The system can have one of three basic configurations:
■ Stand-alone PARTNER Endeavor 362 processor module. This
configuration does not use a carrier.
■ 2-Slot Carrier, which can hold up to two modules. The PARTNER Endeavor
362 processor module resides in the leftmost slot with either a 362EC
expansion module or PARTNER Mail VS (PMVS) module in the right slot.
■ 5-Slot Carrier, which can hold up to five modules. The PARTNER Endeavor
362 processor module resides in the center slot with four 362EC expansion
modules in the remaining slots or three 362EC expansion modules and one
PARTNER Mail VS module in the last slot.
NOTE:
A PARTNER Endeavor PC Upgrade Card is required.
In either carrier, one and only one of the modules must be a PARTNER Endeavor
362 processor module. The modules slide into the carrier, which channels power
to the system.
System Modules
The following system modules can be installed in your system:
■ PARTNER Endeavor 362 Processor Module provides the software
intelligence that controls the system’s features. It has jacks for three
outside lines, eight extensions (the top six station ports support only
Enhanced Tip Ring devices and the bottom two ports support both
Enhanced Tip Ring and Tip Ring devices), a Music-On-Hold audio source
and a grounding screw. It also has one PC Card slot, a bicolor red and
green light-emitting diode (LED), and two AAA user-replaceable batteries.
The module also provides support for Caller ID information on system
display phones. The system requires one PARTNER Endeavor 362
processor module.
■ 362EC Expansion Module provides expanded line and extension
capability. It has jacks for three outside lines and eight extensions (again,
Tip Ring devices are only supported on the bottom two ports). By using
four 362EC expansion modules, you can have a maximum of 40 extensions
with 15 lines (one PARTNER Endeavor 362 processor module and four
362EC expansion modules).
NOTE:
A 362EC expansion module will work ONLY in conjunction with a PARTNER
Endeavor 362 processor module.
To get Caller ID, first you must subscribe to the service from your local phone
company (if it is available) on a per-line basis, then connect those lines associated