Filter
Top Products
System Reset—Programming Saved (#728)
5-203
System Reset—Programming Saved
(#728)
Description
This System Programming procedure resets the system while retaining the
currently programmed settings. Reset the system only when advised to do so by
technical support personnel.
Related Features
After a power failure or system reset:
■ Automatic System Answer Button (#111), Direct Extension Dial
Button (#113), Night Service Button (#503) and Station Lock return to
the status (on or off) that they were in immediately prior to the power failure
or system reset.
■ The VMS Cover button and Privacy button return to the status (on or off)
determined by the programmed setting of Automatic VMS Cover (#310)
and Automatic Extension Privacy (#304), respectively. For example, If
Automatic Extension Privacy is Assigned and the Privacy button is on when
a system reset occurs, the Privacy button will be on again after the system
reset. However, if Automatic Extension Privacy is Not Assigned and the
Privacy button is on when a system reset occurs, the Privacy button will be
off after the system reset.
■ All other active features at an extension are reset to the default settings.
For example, if an extension has calls forwarded to another extension,
resetting the system turns off Call Forwarding (if the feature is
programmed on a button with lights, the reset also turns off the light for the
Call Forwarding button).
■ A successful use of Restore Programming (#125) causes a System
Reset—Programming Saved (#728) to occur.
■ The information stored in the Save Number Redial (F04) and the Last
Number Redial (F05) buffers is lost when a System Reset—Programming
Saved (#728) occurs.
Considerations
■ Resetting the system disconnects all active calls.
■ This procedure is skipped in the sequence of programming procedures
when cycling. To use this procedure, enter the code directly.
■ The system reset begins immediately and takes only a few seconds.
■ You cannot interrupt the reset process or use any telephones in the system
during the reset process.