Filter
Top Products
Feature Reference
5-40
Programming
(See Figure 2-2 on page 2-19 for the location of special programming buttons
such as
s and e on system phones.)
To begin a manual backup of system settings:
1. Verify that a Backup/Restore Card is in the processor module.
2. Press
f 0 0 s s# 1 2 4 at extension
10 or 11.
If there is a problem, see
Chapter 6, ‘‘Troubleshooting,’’
, for explanations
and corrective actions.
Otherwise, the display instructs you to press
e
to begin the backup
.
3. Press
e.
A status message is displayed indicating that a backup is in progress, and
within 30 seconds, a message displays indicating the result.
If the backup was successful, the new backup information replaces the
information in the old MAN.mmddyy file on the Backup/Restore PC Card
and the.mmddyy extension now reflects the current date. Backup
information created during a manual backup does not overwrite any
AUTO.mmddyy file. Go on to Step 4.
If the backup failed and the display shows an error message, go to Step 4
and then see
Chapter 6, ‘‘Troubleshooting,’’
, for explanations and
corrective actions.
4. Exit programming mode.
NOTE:
If you exit the procedure before the backup finishes, you will not
interrupt the backup, but you will not see feedback messages on the
display.