Filter
Top Products
Automatic System Answer Mode (#121)
5-29
■ If Automatic System Answer Mode is set to Hold, calls are placed on hold
at extension 10; however, any extension with access to the line on which
the call is held can retrieve the call.
■ If Automatic System Answer Mode is set to Hold and a call is placed on
hold for longer than one minute, the system generates a short Hold
Reminder Tone at extension 10. This tone sounds once every minute until
the held call is retrieved, or until the caller hangs up.
■ If Automatic System Answer Mode is set to Hold or Disconnect, you can
intercept a call while the message is playing—the light for the call will be
steady red. To intercept the call, press the line button and lift the handset.
The message stops playing when the call is retrieved.
■ If Automatic System Answer Mode is set to Ring, the line button on which
an outside call rings shows green flash continuously, even while the system
answers the call and plays the Automatic System Answer greeting. To
answer the call, lift the handset. If the message was playing, it stops
automatically.
Valid Entries
1 = Hold ✔
2 = Disconnect
3 = Ring
Programming
(See Figure 2-2 on page 2-19 for the location of special programming buttons
such as
s and e on system phones.)
To change the Automatic System Answer Mode:
1. Press
f 0 0 s s # 1 2 1.
2. To change the mode, press
D until the appropriate value displays—
see “Valid Entries.”
3. Select another procedure or exit programming mode.