Filter
Top Products
Feature Reference
5-102
Fax Machine Extensions (#601)
Description
This System Programming procedure identifies extensions to which fax machines
are connected. If you want the fax to receive incoming faxes, the fax machine
extension must be on the bottom two ports of the PARTNER Endeavor 362
processor or 362EC expansion module.
Related Features
■ If you want to monitor fax machine status and make one-touch transfers to
the fax machine, see Auto Dialing to program a Fax Management button
and Using the Fax Management Feature to use the button.
■ To prevent other extensions from interrupting a fax call, program the fax
extension for Automatic Extension Privacy (#304).
Considerations
■ Remove voice messaging system mailboxes from fax machine extensions.
■ If an automatic fax call comes in on a line covered by the PARTNER MAIL
system, the Automated Attendant Service of that system can be
programmed to automatically transfer the call to a fax extension or to the
extension Hunt Group for the fax machines (if you have multiple fax
machines). See the PARTNER MAIL documentation for instructions.
Valid Entries
1 = Assigned
2 = Not Assigned ✔
Programming
(See Figure 2-2 on page 2-19 for the location of special programming buttons
such as
s and e on system phones.)
To identify a Fax Machine extension:
1. Press
f 0 0 s s # 6 0 1 at extension
10 or 11.
2. At the Extension: prompt, enter the extension to which the fax machine is
connected. For example, to identify extension 16, press
1 6.
3. To assign or unassign the extension, press
D until the appropriate
value displays.
4. To program another extension, press
n or p until the
extension number shows on the display. Repeat Step 3.
5. Select another procedure or exit programming mode.