Filter
Top Products
Troubleshooting
6-26
Problems with Manual Backup
Display Shows “Insert Card” in
System Programming Mode
Possible Cause:
The system did not detect a valid Backup/Restore PC Card when
you tried to do
a
manual backup using Backup Programming—Manual (#124).
NOTE:
If an ASA/DXD or PARTNER Voice Mail PC card is in use, perform Backup
Programming—Manual (#124) as described in Chapter 5. Deactivate
automatic backup to prevent this from reoccurring.
What to do:
Power down the system, insert a valid Backup/Restore PC Card in the
PC Card Slot of the PARTNER Endeavor processor module, and reapply power to
the system. Restart the procedure.
Display Shows “Write Protected” in
System Programming Mode
Possible Cause:
You tried to do a manual backup using Backup Programming—
Manual (#124), but the Backup/Restore PC Card in the PC Card slot is
write-protected.
What to do:
Using the end of a paper clip or another pointed object, gently push
the write-protect tab upward to the non-protected position (see Figure 6-7), and
try the procedure again. (You do not need to remove the card from the processor
to slide the write-protect tab up.)
Figure 6-7. Write-Protect Tab on a Backup/Restore PC Card
Slide the switch on the PC card
up to the nonprotected position
ECS
PROC.