Filter
Top Products
Feature Reference
5-122
line covered by the PARTNER MAIL’s Automated Attendant Service, the
PARTNER MAIL system recognizes that it is a fax call and automatically
transfers it to the first available fax machine in the group.
Considerations for Hunt Group 7
This Hunt Group is used exclusively for the extensions associated with the voice
messaging system hardware. Do not assign any other extensions to this group. A
voice messaging system requires special hardware and set up procedures—refer
to Voice Messaging Systems and to the documentation shipped with the voice
messaging system for more information.
NOTE:
When using the PARTNER MAIL system, you can only use the bottom two
ports of the PARTNER Endeavor 362 processor module or 362EC
expansion module.
Valid Entries
1 = Assigned to group
2 = Not Assigned to group ✔
Programming
(See Figure 2-2 on page 2-19 for the location of special programming buttons
such as
s and e on system phones.)
To assign extensions to a Hunt Group:
1. Press
f 0 0 s s # 5 0 5 at extension
10 or 11.
2. At the Group: prompt, enter a group number (1–7). For example, to select
group 1, press
1. The following appears on the display:
Hunt Group 1
Extension:
3. Enter the desired extension number. For example, to select extension 31,
press
3 1.
4. To assign or unassign the extension, press
D until the appropriate
value displays.
5. At this point:
■ To assign or unassign another extension, press n or p
until the extension number shows on the display. Repeat Step 4.
■ To program another group, press N P, enter a
new group number, and repeat Steps 3 and 4.
6. Select another procedure or exit programming mode.