Filter
Top Products
Troubleshooting
6-28
Problems with System Restore
Display Shows “Insert Card” in
System Programming Mode
Possible Cause:
The system did not detect a valid Backup/Restore PC Card when
you tried to do a restore using Restore Programming (#125).
What to do:
Power down the system, insert a valid Backup/Restore PC Card in the
PC Card Slot of the PARTNER Endeavor processor module, and reapply power to
the system. Restart the procedure.
Display Shows “Bad File” in
System Programming Mode
Possible Cause:
You attempted a restore and the file was corrupted.
What to do:
Try Restore Programming (#125) again with a different backup file.
Remember to power down the system before you insert or remove
Backup/Restore PC Cards.
Display Shows “Empty File” in
System Programming Mode
Possible Cause:
You selected a file named AUTO.****** or MAN.****** for the
restore. The file is empty; no backups have been stored in it yet.
What to do:
Try Restore Programming (#125) again using a file created during a
backup procedure. Remember to power down the system before you insert or
remove Backup/Restore PC Cards.
Display Shows “Incompat Versions” in
System Programming Mode
Possible Cause:
You attempted to restore a file that was created with an
incompatible software release.
What to do:
Try Restore Programming (#125) again using a backup file that was
created with the current software release.