Filter
Top Products
Installing the Control Unit
P2
Steps a through e:
Open the power supply
Step i:
Remove the four screws
(one in each corner of
the ring generator)
Step f:
Detach cable
from wire clip
P1
WIRE
CLIP
Step f:
Detach cable
from wire clip
RING GENERATOR
Grip here
P202
P101
Grip here
Step h:
Disconnect the
P101 header
(grip the sides and
pull forcefully)
Step g:
Disconnect the P202 header
(pry the clip away from the header
and pull the header straight up)
Step t:
Wire manager:
make sure the
modification label is
attached when finished;
"Equipped with 129B
Freq Gen"
Figure 2-10. Replacing a Ring Generator
f. Detach the cables from the inside edge of the plastic housing by
removing them from the clips.
2-34
Installing the Power Supply