Filter
Top Products
Connecting Data Equipment
NOTE:
■ The configuration shown in Figure 6-5 is for asynchronous digital
data transmission. For information on setting up synchronous
digital data stations, see “Video Conferencing Data Stations” later
in this chapter.
■ The maximum cord length from the data module to the telephone is
80 ft (24 m).
1. Connect the data terminal to the data module:
a. Connect an EIA-232-D cable to the
SERIAL
connector on the
data terminal.
NOTE:
For any data terminal that has both
COMl
and
COM2
connectors, make sure you use the one designated for data
transmission. See the customer’s system administrator if you
are not sure.
b. Make sure that the data module option settings for parity and
speed are compatible with those settings of the data terminal.
(Speed is synchronized automatically when the factory default
settings remain unchanged.)
If you are not sure about the data terminal option settings, see
the customer’s system administrator or the documentation
packaged with the data module and data terminal.
c. Connect the other end to PORT 1 on the data module.
2. Plug the WP90110-L7 power supply cord into the connector labeled
POWER on the data module.
6-14 Data Stations