Filter
Top Products
Initializing and Testing the System
3.
4.
5.
NOTE:
In Hybrid/PBX systems with pooled tie trunks, press
SA
and dial
the pool dial-out code.
Dial the tie-trunk number of the station where someone is waiting for
your call. You hear ringing.
When the person answers, verify that you have good two-way
communication and hang up.
The green LED should turn off, the red LED will turn off, and another
red LED may turn on.
Repeat Steps 1 through 4 for each outgoing or two-way dial-repeating
tie trunk.
Testing Selected System Features
The procedures in this section, listed below, test selected system features:
■ Automatic Route Selection (ARS), which is for Hybrid/PBX mode only.
Use the same test for Idle Line Preference code, which is a similar
feature that is used in Key mode only.
Use the same test for Station Message Detail Recording (SMDR) as
explained in the test procedure.
■
Group Calling
Use the same test for the Listed Directory Number (the QCC queue),
which is for Hybrid/PBX only.
Use the same test for Group Page.
■ System Speed Dial
■ Coverage
If any feature is not
can run these tests
telephone.
working properly, check the system programming. You
most easily from an MLX telephone or an analog multiline
Testing the System
7-21