Filter
Top Products
Initializing and Testing the System
Testing Outgoing Automatic-Start Tie Trunks
Perform this test for automatic-start tie trunks that are two-way or outgoing
only. If you are testing two-way automatic-start tie trunks, perform the
incoming test as well.
1.
2.
3.
4.
At any telephone that has access to an automatic-start tie trunk, press
the first tie-trunk button.
The red LED next to the tie-trunk button just pressed turns on.
Pick up the handset.
NOTE:
In Hybrid/PBX systems with pooled tie trunks, press
SA
and dial
the pool dial-out code.
The green LED next to the selected button turns on, and you hear
ringing.
When the person answers, verify that you have good two-way
communication and hang up.
The green LED should turn off, the red LED will turn off, and another
red LED may turn on.
Repeat this procedure for each outgoing and two-way automatic-start
tie trunk.
Testing Two-Way Dial-Repeating Tie Trunks
For two-way dial-repeating tie trunks, perform both of the dial-repeating tie
trunk tests (incoming and outgoing).
Testing the System
7-19