Filter
Top Products
Installing Telephones and Adjuncts
c. Insert the plug end of the 400B or 400B2 adapter into the wall
jack.
d. Plug the power supply into a 117-VAC outlet.
The combined total length of the D6AP and D8W cords can be no more
than 50 ft (15 m).
9. Label the DSS designation cards.
a.
b.
c.
d.
e.
NOTE:
Pull the tab at the top of the large plastic cover and rotate the
cover toward you.
Remove the cover and the large designation card.
Write or type the button assignments on the card. For the DSS1,
use the side of the large card that is labeled
00
through
49.
For
the DSS2, use the side labeled
50
through
99.
The button assignments on the designation card should be by
extension number, not by logical ID port number.
Replace the card and the plastic cover. Make sure the coated
side of the cover is facing up.
Repeat these steps to remove the small plastic cover and to
label the small designation card.
If the MLX telephone to which the DSS is attached is unplugged from the
control unit and then again plugged into the control unit, the display on
the telephone may disappear. Press Home to bring back the display.
Installing the Direct Station Selector
3-35