Filter
Top Products
Installing Telephones and Adjuncts
— When connecting the adjunct to a single-line telephone, do the
following:
a. Connect a 267A2 bridging adapter to the telephone.
b. Connect the cord from the adjunct to the bridging
adapter.
c. Reconnect the cord from the control unit to the bridging
adapter.
— When connecting the adjunct to an analog multiline telephone,
do the following:
a.
b.
c.
Connect a 4-pair cord to the
OTHER
jack on the
telephone.
Connect the other end to the
VT
jack on a general
purpose adapter (GPA).
Connect the cord from the adjunct to the TEL/EQUIP
jack on
NOTE:
See the
(GPA),”
.-
the GPA.
next section, “General Purpose Adapter
for additional information.
— When connecting the adjunct to the 012 module, connect the
adjunct cord directly to the logical ID indicated on the system
form.
3. When connecting adjuncts to telephones, make sure you route the
adjunct and D8W telephone cords through the cord channel.
See Figure 3-7.
4. Test the adjunct by dialing its associated extension.
Installing Adjuncts
3-13