Filter
Top Products
Installing the PC, CAT, or Printer
9. Plug one end of a D6AP cord into the 2012D-50M transformer.
NOTE:
If you are working with a 248B adapter and 2012D transformer
instead of a 2012D-50M transformer, plug the D6AP cord into the
jack on the 248B adapter, and then connect the spade-tip wires on
the 248B adapter to the screws on a 2012D transformer
(see Figure 5-5).
10. Plug the other end of the D6AP cord into the lower jack on the 400B2
power adapter.
11. Plug the 2012D-50M (or 2012D) transformer into a wall outlet near the
control unit.
12. At the printer location, plug one end of a D6AP cord into a 2012D-50M
transformer, or follow the instructions given in the note above.
13. Plug the other end of the D6AP cord into the lower jack on a 400B2
power adapter.
14. Plug the 400B2 power adapter into the wall jack.
15. Plug the 2012D-50M (or 2012D) transformer into a wall outlet near the
printer.
16. Plug one end of another D8W cord into the top jack on the second
400B2 power adapter.
17. Plug the other end of the D8W cord into the
WALL
jack on the Z3A2
ADU.
18. Connect the 25-pin male connector on the Z3A2 ADU to the 25-pin
female connector on a second 355AF adapter.
19. Plug one end of a third D8W cord into the second 355AF adapter.
20. Plug the other end of this D8W cord into the SMDR jack on the back of
the CAT.
5-12
Connecting a Printer to the Control Unit