Filter
Top Products
Installing Telephones and Adjuncts
Figure 3-25. Using the D-Impact Tool to Seat the Conductors
5.
6.
7.
8.
iv. Remove any insulation fragments with a spudger (see
Figure 3-23 if you do not know which tool is the spudger).
d. Repeat Steps a through c above for each termination block.
Mount the wire troughs.
As needed, mount the D-rings.
Label the D8W cords, termination blocks, and DIW cables properly.
See “Label the System Wiring” later in this chapter.
Plug one end of a D38W cord into the telephone jack on the control unit
module and the other end into the designated jack on the termination
block. Do this for all telephones.
Connecting the Telephones to the Control Unit
3-51