Filter
Top Products
Installing the PC, CAT, or Printer
Procedure: Connecting the Printer (50 Feet or More)
1.
2.
3.
4.
5.
6.
7.
8.
Plug the short end of the Z200A EMI cord into the SMDR jack on the
control unit (the upper jack).
See Figure 5-4 for the entire procedure.
Plug the other end of the Z200A EMI cord into a 355AF adapter.
Connect the female connector on the 355AF adapter to one end of the
EIA crossover cable.
Connect the other end of the EIA cable to the 25-pin male connector of
the Z3A2 ADU.
CAUTION:
If the printer is in a building outside the main building (control
unit location), an ADU and an additional protector must be
installed in each building. The ADUs and protectors provide
both the control unit and the printer additional protection
against lightning, inadvertent contact with power lines, and
power currents induced by nearby power lines. See the
installation notes packaged with the ADU for more information.
Plug one end of a D8W cord into the
WALL
jack on the Z3A2 ADU.
Plug the other end of this D8W cord into an ADU crossover cable.
Plug the other end of the ADU crossover cable into one of the jacks on
a 400B2 power adapter.
Plug one end of a D6AP cord into the other jack of the 400B2 adapter.
5-18 Connecting a Printer to the Control Unit