Filter
Top Products
Installing Telephones and Adjuncts
MLX telephones are packed fully assembled with the desk stand in the
low position. The angle of any MLX desk telephone can be adjusted to
the high position. If you are wall mounting an MLX-10 or MLX-10D
telephone, you must first remove the desk stand. To remove the desk
stand or adjust its angle, place the telephone face down on a flat
surface and follow these steps:
a. Press on the top rear center of the stand to release the tab(s).
Pull the stand toward you and away from the telephone.
b. To adjust the stand to the high position, insert the tab(s) at the
bottom of the stand into the slot(s).
c. Lower the stand and press the tab(s) at the top into the
corresponding slot(s) on the telephone.
NOTE:
The diagram on the bottom of the user card tray also shows
the steps to adjust the stand.
2. Connect the line cords. See Figure 3-7 earlier in this chapter.
a. Plug one end of the D8W cord into the telephone jack labeled
LINE
on the underside of the telephone.
b. Route the D8W cord through the cord channel on the back of
the telephone.
c. If the telephone is for desktop use, turn the desk telephone face
up and plug the D8W cord into the wall jack.
3. Install the handset by inserting one end of the coiled H4DU handset
cord into the handset and the other end into the jack on the side of the
telephone.
Assembling the MLX Telephone
3-37