Filter
Top Products
Installing Applications
Hardware Requirements
The Master Controller II+ (Desktop) and the Master Controller III (Tower) are
the PC platforms for IS III.
The Master Controller II+ is a desktop 20 Mhz, 386-SX PC with three available
AT bus slots (with the tape drive installed). It has 8 Mbyte of RAM memory,
either 100 Mbyte or 200 MB hard disk drive, 3.5 inch floppy drive, and
125 Mbyte streaming tape drive.
The Master Controller III is a tower 20 Mhz 486-SX PC with six available EISA
bus slots (with the tape drive installed). It has 8 Mbyte of RAM memory, either
200 or 500 Mbyte hard disk drive, and 250 Mbyte streaming tape drive.
■
■
■
■
■
■
A 355AF adapter for connecting the Master Controller to the serial port
on the control unit if they are within 50 ft (15 m) of each other and are
on the same AC branch circuit
ADUs for connecting the Master Controller to the serial port on the
control unit, if they are not within 50 ft (15 m) of each other and/or are
not on the same AC branch circuit
Any additional hardware required by the individual applications
included in IS-III, including the cables and adapters for connecting the
applications to the system
IVP4 boards or IVP6 cards for AUDIX Voice Power and FAX Attendant
012 basic telephone module to provide the tip/ring interface for AUDIX
Voice Power
TR114 boards for FAX Attendant
8-20
Integrated Solution III