Filter
Top Products
Installing Telephones and Adjuncts
DSS Installation Procedure
NOTE:
If you are connecting two DSSs to the telephone, unpack the second DSS
now.
1. Adjust the angle of the DSS. For instructions on removing the telephone
stand, see Figure 3-2 earlier in this chapter.
The DSS is packed fully assembled with the desk stand in the low
position. If you-prefer the low position, go to Step 2. To adjust the
angle of the DSS to the high position, place the DSS face down on a
flat surface and follow these steps:
a.
b.
c.
2. Install
a.
b.
Press on the top rear center of the stand to release the tab. Pull
the stand toward you and away from the DSS.
To adjust the stand to the high position, insert the tab at the
bottom of the stand into the other slot.
Lower the stand and press the tab at the top into the
corresponding slot on the DSS.
the D8AC cord on the DSS. See Figure 3-14.
There are two jacks on the DSS labeled
IN
and
OUT.
Plug one
end of the D8AC cord into the jack labeled
IN.
Route
of the
■
■
3. Wire the two
a. Place
the D8AC cord through the cord channel on the left side
DSS.
If you are installing one DSS, go to Step 4.
If you are installing two DSSs, repeat Steps 1 and 2 for
the second DSS; then go to Step 3.
DSSs. See Figure 3-14.
the two DSSs side by side and face down.
3-32
Installing the Direct Station Selector