Filter
Top Products
Installing the Control Unit
9. Connecting the control unit to AC power
10. Powering up the system
11. Powering down the system
Be sure to follow these procedures in the order specified.
Preparation
The control unit must be installed on a backboard, which may already be
installed. If so, skip to the section, “Power and Grounding.”
If backboard installation is your responsibility, follow the procedures in this
section.
Environment
The placement of the control unit requires careful consideration. Make sure
you install the backboard in an area that meets all of the environmental
requirements listed in Table 2-1.
2-2
Preparation