Filter
Top Products
Initializing and Testing the System
5. Convert the backup file
(only when upgrading to Release 2.0).
This procedure converts the backup file created in Step 2 to the
Release 2.0 format.
6. Restore the system programming,
The system is forced idle and cannot be used during this procedure.
Complete instructions can be found in the section entitled “Restore.”
To upgrade to Release 1.1, Use Version 1.16 or 2.xx or higher of SPM
and restore the backup file you created in Step 2.
To upgrade to Release 2.0, Use Version 2.xx or higher of SPM and
restore the file you converted in Step 5.
7. Program new features, if necessary.
See the System Programming guide for detailed procedures on
programming.
Upgrading from the MERLIN II Communications System
To upgrade to Release 2.0 from the MERLIN II Communications
the following:
1. Install SPM.
To upgrade your communications system to Release 1.1, you will need
to install (or, on a UNIX system PC, upgrade to) Version 1.16 of SPM
To upgrade your communications system to Release 2.0, you will need
to install (or upgrade to) Version 2.xx or higher of SPM.
2. Remove the control unit housing.
See Chapter 2 for instructions, if necessary.
System, do
3. Replace old modules and add new modules as indicated on the
Control Unit Diagram of Form 1, System Planning.
See Chapter 2 for instructions, if necessary.
Initializing the System
7-7