Filter
Top Products
Installing the PC, CAT, or Printer
Connecting a Printer (Within 50 Feet)
If the printer is within 50 ft (15 m) of the control unit and is connected to the
same 117-VAC branch as the control unit, use the hardware and procedures
in this section.
Hardware
■
Z200A EMI filter
■
adapter for the connector on the interface cable
— 355A for a male connector
— 355AF for a female connector
Procedure: Connecting the Printer (Within 50 Feet)
1. Plug the short end of the Z200A EMI cord into the SMDR jack on the
control unit (the upper jack).
See Figure 5-3 for the entire procedure.
2. Plug the other end of the Z200A EMI cord into the adapter (355AF or
355A).
3. Connect the female connector on the adapter to the 25-pin male
connector on the printer’s interface cable, or into the parallel or serial
port (depending on the printer type) on the printer.
4. Set the printer options for use with the SMDR feature. See the section,
“Setting Printer Options,” for the appropriate printer setting for the
printer.
5-14 Connecting a Printer to the Control Unit