Filter
Top Products
REMOTEAOMIN & MAINTPROCEDURES
SECTION 200-096-600
FEBRUARY1991
TABLERM-H
TYPEIPROGRAMPROCEDUREEXAMPLE
(PROGRAMS: IO-I, 10-2, 1 O-3, 15-0, 15-1, 16,42-O, 77-1,77-2)
.
STEP/ ACTION
DISPLAY/PRINTOUT
1
Enter Program Mode
>MODE PROG
0
At the >MODE prompt, enter B 1 m @
q
.
P
2 Enter Program Number
P 10
Refer to the record sheet and enter the desired
Example:
Program IO-I,
enter 0 1, press
d
rogram number.
PlO
- .
Enter Program Code or Digit(s) Per Record Sheet
3 El
or other digit required.
PlO 1
NOTE: Most programs do not require a second digit.
4 Enter Key/LED Number
PlO 1 01 g (see
note)
Enter the desired key/LED number.
I
Example: Key/LED 01, enter 1 n .
5 To Change Key/LED Status
Pl0 1 01 N Y
Refer to the System Record Sheet and change the key/LED
status, if required (Y or N).
Example: Enter 1
6 To Advance to Next Key/LED
PlO 1 01 Y
Press m Repeat step 5 if necessary.
02 N
7 To Review Key/LED Status Change
Enter
q
.
PlO 1
01 Y- Key LED “ON”
-
Re-enter steps 3 and 4.
Key LED Number
Program Code
NOTE:
This step is optional and not required to save data. LL
Program Number
8 To Exit Program/Store Data
PlO
A) To store data, press
q
B) To exit this program, press 1 1, then press
q
.
PlO ##
P
C) Continue returning to step 2 until all Type 1 programs
are completed.
9
To Exit the Program Mode
> MODE
Pressu[m .
IO
To Enter Another Mode
Press
mmmim (datadump)
OlMiW (test)
m 0 H H q
(LCD messages)
moii[9 (speed dial)
NOTE:
Y = key/LED “ON’: N = key/LED “OFF”
D
T
(no prompt)
R
-16B-