Filter
Top Products
PROGRAMMINGPROCEDURES-INTRODUCTION
SECTION 200-096-301
FEBRUARY1991
TABLEl-B
MULTIDIMENSIONALPROGRAM: PROGRAM30
(STATION CLASS OFSERVICE)
Press...
Step
m + LED keys
#
Action description
LCD RESPONSE . . .
I
1. Use the programming LCD digital or electronic
NO. 205
telephone connected to port 05 - circuit 6. JAN 20 SUN
06:43
Make sure the programming button strip template is
installed on the programming telephone (see
Paragraph 3.24).
2. m[[E[
PROGRAM MODE
Enter programming mode.
3. =Nlm
PROGRAM = 30
Access Program 30. System beeps after m
DATA STORE
key is pressed to indicate a program number may
be entered.
4. m 30
SELECT =
Prepare system for a port number selection.
5. ml! -IRE 30 SELECT = (00 - 95)
Enter the port number where the station bein
is connected. Use two digits, followed by a * key.
If
defined
A range of ports may be entered at once by using the
1 key. (See Note on system record sheet.)
6.
LED keys 01 - 20
LED keys 01 m 20 activate features for each station port
or port range. Make the following selections by turing
the appropriate key led ON or OFF for each item (01 m
20) for each port, as marked on the system record
sheet:
LED 01: Speakerphone Enabled.
LED 02: Microphone Key Lock Enabled.
LED 03: Microphone ON at Start of Call.
LED 04: Not Used.
LED 05: Speed Dial Allowed.
LED 06: Automatic Busy Redial Access Enabled.
LED 07: Automatic Off-hook Call Announce.
LED 08: Forced Account Code Enabled.
LED 09: Toll Restriction Override Code Revision
Authority
LED 10: DISA Security Code Change Allowed
LED 11: Dial Pulse (DTMF Off) for Standard
Telephone
1-4