Filter
Top Products
FEATURE USE FEATURE USE
SPEED DIAL BUTTONS
PROGRAMMABLE OPTION (continued)
4. To store * or # DTMF tones in soeed dial numbers. the
telephone that stores the numbers must have them
and m buttons.
SAVED NUMBER REDIAL
PROGRAMMABLE OPTION
This feature enables you to store a dialed telephone number and
later redial that number by pressing a single button.
TO SAVE A TELEPHONE NUMBER
1) Lift the handset.
2) Obtain dial tone.
3) Dial the desired telephone number.
4) Press the m button.
l
The telephone number is saved for future use.
TO DIAL A SAVED TELEPHONE NUMBER
1) Lift the handset.
2) Obtain dial tone.
3) Press the m button.
l
Saved number will be automatically dialed.
TELEPHONE NUMBER STORAGE
STORING A SYSTEM SPEED DIAL NUMBER
System speed dial telephone numbers can be stored in the
system memory by station 200 only.
1) Do not lift the handset.
2) Press the 1 and p (or m and m) buttons, respectively.
3) Dial a 2-digit speed dial code.
l
System speed dial codes run consecutively from 60 N
99.
4) Dial the telephone number to be stored (20 digits maxi-
mum).
5) Press them(orm) button to record the telephone number
in memory.
TELEPHONE NUMBER STORAGE (continued)
6) Repeat the steps above with every telephone number to be
stored (up to the maximum of 40).
7) Write down the speed dial codes and telephone numbers
for future reference.
NOTE:
Repeat steps I
N 5 to replace the stored telephone num-
bers with new ones.
TO STORE PAUSES (l/2- or 2-second/lo-second) and
FLASHES (Hookflash) ALONG WITH SPEED DIAL NUMBERS
r m) button to store a pause.
button to store a flash. The flash must be
stored as the first entry: a flash cannot be stored after a digit
is entered into the speed dial number.
NOTES:
7. If am button is not available, them button will
store auses only, not flashes.
Lb
2. The 8i button is i/2- or 2-seconds per system pro-
gram assignments.
3. A lo-second pause is programmed using the m
button.
STORING A STATION SPEED DIAL NUMBER
Speed dial telephone numbers can be stored by each station.
1) Do not lift the handset.
2) Press the 1 and 1 (or m and m buttons, respectively.
3) Dial a 2-digit speed dial code.
l
Station speed dial codes run consecutively from 10 *
49.
4) Dial the telephone number to be stored (20 digits maxi-
mum).
5) Press the 1 button to record the number in memory.
6) Repeat the above steps with every number to be stored (up
to the maximum of 40).
7) Write down the speed dial codes and telephone numbers
for future reference.