Filter
Top Products
FEATURE USE
FEATURE USE
CALL TRANSFER WITH CAMP-ON CALL TRANSFER WITH CAMP-ON (continued)
Allows you to transfer an outside call to a station that is either idle
or busy.
TO TRANSFER A CALL
1) While connected to an outside call, press them
button.
l
CO LED remains green, but changes to the Confer-
ence fast flash rate.
l
INT LED flashes at the In-use rate.
2) Dial the station number to which the call is to be transferred.
3A) If the called station is idle:
l
You hear a single ring tone.
4A) Announce the call.
5A) Hang up.
l
INT LED goes off.
l
CO LED remains green, but changes to the On-hold
flash rate.
l
CO line rings the called station.’
l
CO LED changes to steady red when the called station
connects with the transferred call.
l
If the station fails to answer the call, you will receive a
recall ring after a predetermined time.
. . .
or. . .
38) If the called station is busy:
l
Busy tone is heard.
4B) Hang up.
l
INT LED goes off.
l
CO LED remains green, but changes to On-hold flash
rate.
l
CO line is camped-on to the called station.’
l
Called station hears a warning tone.
l
CO LED changes to steady red when the station
connects with the transferred call.2
NOTES:
1. You may reconnect to a transferred line (anytime
before it is answered) by pressing the appropriate
q
button or dia/m [ 1 if them line does not appear on
your telephone.
2. The call will recall you and camp-on is cancelled if the
station does notpick it up within a predetermined time.
Inform the caller of the situation, and repeat the proce-
dure (if necessary).
TO ANSWER ATRANSFERRED CALL (if your station is idle)
1) Voice Signaling:
a) You will hear a single long tone, followed by an
announcement.
l
INT LED flashes green at the Incoming Call rate.
b) Acknowledge the announcement.
c) When the transferring station hangs up, you will hear
a ringing tone.
l
CO LED changes from red to green at the Incom-
ing Call flash rate.
d) Press the appropriate
q
button.
l
CO LED changes to the In-use flash rate.
NOTE:
If your digital telephone has Line Preference
feature, you may press the button or lift the
handset instead of pressing the [9 button,
2) Tone Signaling:
a) You will hear intercom ringing.
l
INT LED flashes green at the Incoming Call rate.
b) Lift the handset (or press the B button).
l
INT LED changes to the In-use flash rate.
c) Speak to the transferring station.
d) You will be connected to the outside call when the
transferring station hangs up.
l
INT LED goes off.
l
The LED of the transferred CO line changes to
green at the In-use flash rate.
24
25