Filter
Top Products
INSTALLATION-PERIPHERALS
SECTION 200-096-208
FEBRUARY1991
STRATA DK (Release 3)
nnne I
RS-
RS-
FlGURE8-36-PCTO PRINTERTESTCALL USING MANUAL DIALING
l
PC 1 and PC 2 screens both display,
NO CARRIER.
l
The Data LEDs on each DKT are off.
12.83 PC to Printer Test Call Using Manual
Dialing (see Figure 8-36)
1) DIU Programming:
l
Program 20: Port 01. LEDs 01, 02, and
17 ON; all other LEDs OFF.
l
Program 20: Port 03. LEDs 01,04, and
17 ON; all other LEDs OFF.
l
Program 39: Port 01. m (56) and
m (54) buttons should be provided.
l
Default settings for PDIU-DI, S-Registers.
2) Make sure the PC is configured to print data
from its serial COM port (the PC COM port
connected to DKT/PDIU-DI port 01). This is
normally accomplished using the DOS and
MODE commands.
3) Using the manufacturer’s documentation,
make sure the communication parameters
(data speed, parity, data bits, stop bits, etc.) of
the PC COM port match the printer’s serial
interface parameters.
4) To connect the PC to the printer, press the
DKT’s m button and dial 111 .
l
The CONNECT on the PDIU-DS will be
lit.
l
The connection between the PC and the
printer is completed, as shown by the
thick lines above (PDIU-DS 203 is in the
communication mode).
l
If busy tone is sent to the DKT, the
connection is not complete; press m
and try step 4 again.
5) Operate the PC to print data as required.
6) To terminate the call, press the DKT’s m
button.
I
8-56