Filter
Top Products
PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 200-096-302
FEBRUARY 1991
PROGRAM 12
SYSTEM ASSIGNMENTS - BASIC TIMING
SELECT = i-9 SELECT CODE = Enter required
Enter program code,
code for the time listed in the
3 - 9, from table below. table below. See Note 3.
Brogram Code Function Time
Required
Code
36
46
5
9
Pause Timing
q
1 1.5 sec.
(Speed Dial) 0 2 3.0 sec.
0 1 0.5 sec.
Flash Timing4 0 2 2.0 sec.
W
q
0.2 sec.5
0 0 no pause
Pause After Flash
(Voice Path Delay) 0 1 1.5 sec.
0 2 3 sec.
CRCU Inter-digital Release
0 1 1 sec.
Time (Standard Phone)
through through
9 sec.
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data programs timing as follows: Code 3 = 1, Code 4 = 2, Code 5 = 0, and
Code 9 = 4.
3. When programming Code 9, the LCD responds with LINE TIME = instead of SEL ECT
CODE =.
4. The duration of time the PCOUcircuitopens Tip & Ring when them keyispressed,
or hookflash code m 11 is dialed.
5. This timing is not used in the United States.
6. This timing applies to voice calls originated from telephones and voice or data calls
originated by system Data Interface Units (PDIU-DI or -DS).
:
‘,
.!
2-56