Filter
Top Products
PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECORDS
SECTION 200-096-302
FEBRUARY1991
PROGRAM lO-3(Release 3)
TWOCO-LINECONFERENCE/DlSAAMPLlFlERCONNECTlONPORTASSlGNMENTS .
~-pJq-qpq-py-q-j-JpqT-pl
7 \
SELECT = 3 Key LEDs
Light LEDs as defined by the table below.
ALL LEDs with an ‘x” should be lit when you finish.
06
05
(R3) 04
(R3) 03
(R3) 02
(R3) 01
PEKU Ports 33,34 - Amp. 4 Connected
Ports 33, 34 - Stations Connected
PEKU Ports 25,26 - Amp. 3 Connected
Ports 25,26 - Stations Connected
PEKU Ports 17,18 - Amp. 2 Connected
Ports 17,18 - Stations Connected
PEKU Ports 09, IO - Amp. 1 Connected
Ports 09,lO - Stations Connected
NOTES:
1. For more information, see the
2. Initialized data: all LEDs off.
instructions
preceding the record sheets.
3. See Section 200-096-208, Paragraph 13 for connecting up to four two-way amplifiers for use on tandem,
DISA and conference telephone calls.
4. Important: Only enable the PEKU ports that are actually connected on amplifiers.
5. Amplifiers are switched into two-CO line calls automatically, one amplifier for each call, starting from the
lowest ports enabled to the highest. Skipping ports is allowed. Two-CO line calls established after all
amplifiers are in use will not be amplified.
6. See Program 10-2, LED 18 and 19; Program 10-1, L EDs 19 and 20; and Program 15-5 for more
information regarding two-CO line conference/tandem.
2-55