Toshiba DK96 Telephone User Manual


 
FEATURE USE
FEATURE USE
TONE/PULSE DIALING
PROGRAMMABLE OPTION (continued)
TO CHANGE TO TONE SENDING
After you have dialed a telephone number and the call is in
progress, press the m button.
TONE LED goes on.
Pressing the dialpad buttons will cause DTMF tones to be
transmitted.
NOTE:
After :hem button is pressed, the Tone LED will remain
on and DTMF tones will be sent when dialing until the call
is released. When originating or receiving a new CO line
call, the system automatically places the line in the dial
pulse mode until the m button is used.
PRIVACY OVERRIDE
PROGRAMMABLE OPTION
Allows stations with common CO lines to override an existing
conversation by pressing the busy
q
line button. Up to two
stations maximum may override an existing CO line-to-station
call (allowing a total of up to three stations being connected to an
outside line).
TO ENTER AN EXISTING CALL BETWEEN A CO LINE AND
ANOTHER STATION
Press the busy m line button.
l
An optional tone signal is heard by the connected parties prior
to the new station entering the conversation.
NOTE:
To allow Privacy Override, the overriding station must be
programmed with Privacy Override; or, the Privacy Re-
lease LED must be on at the talking station (see Privacy
Release).
PRIVACY OVERRIDE (continued)
PROGRAMMABLE OPTION
PRIVACY BUTTON
PROGRAMMABLE OPTION
This option blocks any station programmed with Privacy Over-
ride from entering your CO line conversation by pressing a
common CO line button.
TO MAKE ALL CO LINES ON YOUR STATION PRIVATE
Press the m button.
TO CANCEL PRIVACY
Press the m button again
NOTE:
Privacy willnot block Busy Override or Executive Override.
PRIVACY RELEASE
PROGRAMMABLE OPTION
On a private system, activating them button allows any
other station to enter an in-progress CO line call (see Privacy
Override).
TO USE PRIVACY RELEASE FEATURE
Press the m button.
l
PRV RLS LED goes on.
l
Your station does not have CO line privacy.
INTERCOM CALLS
TO MAKE AN INTERCOM CALL (Voice First)
1) Lift the handset.
2) Press the m button (see Note).
l
You hear intercom dial tone.
31