Filter
Top Products
REMOTE ADMIN & MAINT PROCEDURES
SECTION 200-096-600
FEBRUARY 1991
TABLE RM-I
TYPE 2 PROGRAM PROCEDURE EXAMPLE
.
,81 - 89)
DISPLAY/PRINTOUT
>MODE PROG
P
I
(PROGRAMS: 17,20,30,31,35,40,41,43,
i
ACTION
iTEF
1 Enter Program Mode
At the >MODE prompt, enter 4 1 m 1
q
.
Enter Program Number
Refer to the record sheet and enter the desired program number.
Example: Program 30, enter1 m, press
q
.
Enter Port Number 0 0 or Port Range 0 0 10 0
Refer to the System Record Sheet and enter the desired
port number(s). Example: 1 1.
Press i key.
2
P
30
3
P30
P30 04
4
P30 04#
5 Enter the Desired Key/LED Number
Example: Key/LED 01, enter: 1 0.
P30 04#
01
N_ (Note
iIf
6 To Change Key/LED Status
Refer to the System Record Sheet and change the key/LED
status, if required (Y or N).
Example: Enter a
P30 04# 01 N Y
7 To Advance to Next Key/LED
Press m (repeat step 6 if necessary).
8 To Review Key/LED Status Change
Press
q
Re-enter steps 3, 4, and 5.
9 To Exit Program/Store Data
A) To store data, press
q
B) To exit this program, press 1 1, then press
q
.
C) Continue returning to step 2 until all Type 2 programs
are completed.
>MODE
To Exit the Program Mode
Press aim
11 To Enter Another Mode,
Press
NImlm (datadump)
OINIm (test)
~~~~~ (LCD messages)
~~~~~ (speed dial)
D
T
(no prompt)
R
VOTE:
Y = key/LED(s) “ON”, N = key/LED(s) “OFF”; U = key/LED(s) ‘0N”some parts and ‘OFF” other parts,
-17-