Filter
Top Products
FEATURE USE FEATURE USE
HANDSFREE ANSWERBACK
TO RECEIVE AN INTERCOM CALL (HANDSFREE)
1) You will hear a single long tone, followed by the caller’s
voice.
l
INT LED flashes at the Incoming Call rate.
2) Leave the handset on-hook.
3) Speak at a normal voice level in the direction of the
telephone.
NOTE:
The m button must be pressed (or the handset must be
taken off-hook) before placing an intercom call on hold.
MICROPHONE CUT-OFF
PROGRAMMABLE OPTION
The m button allows a station to turn its microphone off/on
while idle. Handsfree Answerback is inoperable while the micro-
phone is off; provides privacy by blocking room monitor to calling
parties.
TO USE MICROPHONE CUT-OFF
1) Press the m button.
l
MC0 LED goes on.
l
Micro hone is turned off.
2)
Press the
km
0 button to turn the microphone on again.
l
MC0 LED goes off.
NOTE:
Functional when telephone receives calls, them button
controls the microphone when the telephone originates
calls.
OFF-HOOK CALL ANNOUNCE (OCA)
OPTIONAL FEATURE
Allows a .station user to call and speak to an off-hook, busy
electronic telephone through the speaker, if that called station
has optional OCA feature.
OFF-HOOK CALL ANNOUNCE (OCA)
OPTIONAL FEATURE (continued)
TO USE OFF-HOOK CALL ANNOUNCE
1) Lift the handset.
2) Call the desired station.
l
Hear warning tone.
l
If busy tone is heard, dial 1.
3) Speak to called party (automatic OCA).
TO FORCE A DISCONNECT
A forced disconnect allows the called station to disconnect the
OCA call.
l
Press the SPKR button to disconnect an OCA caller.
NOTES:
1. DND revents OCA calls.
2. The
I&
andm buttons can prevent the OCA caller
from listening to your conversation.
CALL TRANSFER WITH CAMP-ON
Allows you to transfer an outside call to a station that is either idle
or busy.
TO TRANSFER A CALL
1) While connected to an outside call, press them
button.
l
CO LED changes to the Conference flash rate.
l
INT LED flashes at the In-use rate.
2)
Dial the station number to which the call is to be transferred.
3A) If the called station is idle:
l
You hear a single ring tone.
4A) Announce the call.
5A) Hang up.
l
INT LED goes off.
l
CO LED changes to the On-hold flash rate:
l
CO line rings the called station.’
20
21