Filter
Top Products
FEATURE USE
PRIVACY OVERRIDE
PROGRAMMABLE OPTION
Allows stations with common CO line buttons to override an
existing conversation by pressing the busym line button. Up to
two stations maximum may override an existing CO line-to-
station call (allowing a total of up to three stations being con-
nected to an outside line)
TO ENTER AN EXISTING CALL BETWEEN A CO LINE AND
ANOTHER STATION
Press the busy
q
line button.
l
An optional tone signal is heard by the connected parties
prior to the new station entering the conversation.
NOTE:
To allow Privacy Override, the overriding station must be
programmed with Privacy Override; or, the Privacy Re-
lease LED must be on at the talking station (see Privacy
Release).
PRIVACY BUTTON PROGRAMMABLE OPTION (Release 3
only)
This option blocks any station programmed with Privacy Over-
ride from entering your CO line conversation by pressing a
common CO line button.
TO MAKE ALL CO LINES ON YOUR STATION PRIVATE
Press the m button.
TO CANCEL PRIVACY
Press the IswLll,‘;m’l button again
NOTE:
Privacy will not block Busy Override or Executive Override.
PRIVACY RELEASE
PROGRAMMABLE OPTION
The m button allows any other station to enter an in-
progress CO line call (see Privacy Override).
TO USE PRIVACY RELEASE FEATURE
Press the m button.
l
PRV RLS LED goes on.
l
Your station does not have CO line privacy.
l
Any station user can press a common CO line button to
enter your conversation.
INTERCOM CALLS
TO MAKE AN INTERCOM CALL (Voice First)
1) Lift the handset.
2) Press the m button (see Note).
l
You hear intercom dial tone.
l
INT LED flashes at the In-use rate.
3) Dial the desired station number.
l
You hear a single ring tone.
4) Speak when the ring tone ends.
5) Hang up when the call is completed.
NOTES:
1. See Automatic Off-hook Selection.
2.
Tone Signaling can be accomplished by dialing0 after
the station number.
TO RECEIVE AN INTERCOM CALL
1)
You hear a single long tone, followed by the caller’s voice.
l
INT LED flashes at the Incoming Call rate.
2) Lift the handset.
l
INT LED flashes at the In-use rate.
3) Hang up when the call is completed.
18
.,_..
19
x _a.,’