Filter
Top Products
PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 200-096-302
FEBRUARY 1991
IMPORTANT NOTE:
assigned to groups 81
- 88. Refer to the com-
Always provide emergency service ac-
pleted record sheet in
Program 16
for this
cess for numbers such as 911.
information.
.
6.24 Basic System Record programs related to
LCR include:
2)
3)
4)
Under the column labeled “CO Line Type/Corn-
ments,” enter the service type, the common
carrier name, or the line type for each line
group, e.g., local line, Foreign Exchange (FX)
to 818 (LA), WATS (out of state), etc.
Program
16 defines which outgoing CO lines
are assigned to CO line groups 81 - 88.
Program
40 denies a station complete CO line
access. This also applies to LCR.
Program 41
restricts outgoing CO line calls to
selected stations. These stations may make
outgoing calls through LCR. In this Program,
Release 1
software denies ABR;
Release 2
and above software allows ABR.
7 COMPLETING THE LEAST COST
ROUTING SYSTEM RECORD
NOTE:
All stations using LCR should be ALLOWED
CO
line access in
Program
40, and DENIED
CO
line access in
Program 41.
7.01 The following instructions explain comple-
tion of the System Record Sheets used to program
LCR. Instructions are arranged in the same order
as data tables in the Least Cost Routing System
Recordand the programming instruction tables in
Chapter 3. The instructions are intended to give a
concise, general definition of LCR characteristics
defined by each record sheet.
NOTES:
1. On each record sheet, enter required data
in the space provided to make a selection,
unless otherwise specified.
2. The initialized state and considerations
are documented on the record sheet.
7.10 LCR CO Line Programming Reference
Table
7.11
This table is intended for reference only.
Information relevant to LCR is compiled here from
Basic System Programming.
1) Under the column labeled “CO Lines in Group
(01 - 36),” enter the numbers of the CO lines
Refer to Basic System Record,
Program 40,
to
restrict stations from incoming and outgoing
access of CO lines, including using LCR. All
stations that must use LCR to make outgoing
calls must NOT be restricted in this program.
These restrictions do apply to LCR.
Refer to Basic System Record,
Program 41,
to
restrict stations from accessing outgoing CO
lines, except through LCR. All stations that
must use LCR for outgoing calls must be re-
stricted from CO line access in this program.
7.20 Program 50 Series-LCR Definitions
7.21 Program 50-I-LCR Parameters:
This
program defines general operating parameters for
LC R software.
NOTE:
Mark an X in the column to indicate which
programming button LEDs should be lit. Ini-
tialized data leaves all L EDs OFF.
LED Key 01
ON: LCR software is enabled system-wide.
OFF:
LCR software is disabled. None of the
LCR programming referred to by this section is
recognized. Dial 9 access assigned in
Program
16
is enabled.
LED Key 02
l
Not used.
LED Key 03
l
ON: LCR routes long distance information
(LDI) calls over the plan number specified in
Program 50-4.
2-28